You may enjoy taking hot water baths. Like any electronic device, a water heater requires proper installation and routine maintenance. You may have purchased the best quality water heater dealing with constant heating/cooling. But with time, it is likely to wear down due to continuous pressure. Hence, you should seek professional water heater installation and maintenance services. They will prolong its life.
Installation tips
Hot Water Repairs Burwood professionals suggest the following installation tips.
- Place device at a height: Install the water heater approximately 6 feet or 1.8m from the floor. It ensures sufficient water pressure. Your tap will let out a strong flow of hot water instead of a trickle.
- Space around the device: Maintain sufficient space between the device and the walls. This space will enable technicians to check the parts for wear and tear or damage. It also provides them with enough room to repair or service it properly.
- Electrical switches and connections: Ensure the device is connected to an MCB (Miniature Circuit Breaker) to cut-off electricity during extreme power fluctuations. It reduces the chances of a short circuit occurring in the device. Place the switch away from the reach of small children.
Maintenance tips
- Lower temperature to save precious electricity: Routine maintenance helps save electricity. Lower temperature setting. The water reaches the desired temperature faster. Thus, reduced temperature ensures the device will work less, prolonging its lifespan. Your tap should let out warm and not hot water to reduce accidental burns. Lowering the thermostat is crucial if you have small children.
- Avoid operating the device for extended periods: During morning hours, it is natural for people to switch on their water heaters for extended periods to save time. Modern technology has enabled new devices to heat water quickly. Hence, keeping the device switched on for extended periods tends to damage its parts and reduces its lifespan.
- Monitor the plug: Low capacity wiring and power fluctuations will frequently create a spark in your switch. Higher electricity wattage heats the pins and plugs, thereby leaving burn traces on the plug’s pins. Hence, use quality sockets and plugs. The experienced 24 Hour Emergency Plumbing will take care of all issues and ensure the devices function to their optimum.
- Check pressure release valve: Carry out annual checks to determine if pressure release and temperature valves are functional. Release pressure a few times to check it. In case the relief valve leaks, it will become a major issue. From the device drain some water. Then, remove the discharge tube and replace the leaking, damaged valve with a new one.
- Use metal ones instead of plastic outlets and inlet pipes: Always use metal outlets and inlet pipes. When compared to standard plastic types, metal ones are more heat resistant. Check joints regularly. If rust is found around joints or whitish deposits appear from hard water, replace the outlet or inlet pipe.
Perform annual maintenance
Perhaps you don’t have essential experience or knowledge in carrying out maintenance work on the water heater. Don’t worry! You may always hire industry experts to carry out annual maintenance and repair work. The well-established professionals have the necessary resources to perform emergency services.
